How to reverse conveyor motor

Discussion in 'The Think Tank' started by Joe D, Jul 7, 2019.

  1. Joe D

    Joe D New Member

    Joined:
    Jul 7, 2019
    Messages:
    1
    Likes Received:
    0
    Location:
    MA USA
    Hello all,

    I have a Blodgett MG-32 and I can't seem to figure out how to reverse the conveyor direction. Attached are pictures of the oven, the motor connector, and the wire.

    Thanks
     

    Attached Files:

  2. George Mills

    George Mills Well-Known Member

    Joined:
    Feb 25, 2007
    Messages:
    1,985
    Likes Received:
    143
    Location:
    Livonia MI
    Generally reversing the wires connecting the power to the devise will change the direction.
     
  3. Joseph Malovich

    Joseph Malovich New Member

    Joined:
    Jul 31, 2014
    Messages:
    1
    Likes Received:
    0
    if it's a DC motor then reversing the wires will change direction. If it's AC then reversing the wires might change direction but unlikely.
     
  4. BrScott

    BrScott New Member

    Joined:
    Jul 10, 2019
    Messages:
    2
    Likes Received:
    0
    Location:
    Vermont
    Hi Joe. I'm can't clearly see the P1 pins in your picture. However, I believe they are on the right side of your full circuit board photo. There should be 3 silver pins sticking out next to a label that says P1. Two of the pins are covered by a connecting cap that completes the circuit. If you pull off that cap to expose all 3 pins and move it to cover the center pin (that was already covered) and the pin that was not covered, it should change the direction of your motor. Hope that works. Let me know if you need more detail or a photo.