Middleby Conveyor won't work

Discussion in 'The Think Tank' started by durbancic, Sep 27, 2019.

  1. durbancic

    durbancic Active Member

    Joined:
    Jun 16, 2011
    Messages:
    487
    Likes Received:
    91
    Location:
    Ohio
    Getting an ERR message on the timer on my lower conveyor on my PS 360. Oven is 12-13 years old. Middleby said that it could be a loose wire on the speed controller. Opened it up and all wires are tight. Anyone have any ideas? In the past when conveyor motors have died the oven did not show this error message.
     
  2. Registered Guest

    Registered Guest Well-Known Member

    Joined:
    Feb 28, 2007
    Messages:
    1,078
    Likes Received:
    68
    More that likely either dust build up between the speed sensor pickup and the spinning magnet, or a motor brush is worn out. Can you post a picture of the motor?